Setting up floor tile could be a gratifying experience if you are planning the installment ahead of time, and take the appropriate steps when positioning the pieces. Naturally, preparing in advance is definitely critical when putting in flooring – regardless of whether you are putting in hardwoods, vinyl, or decorative stone – but ornamental tile presents a number of distinctive challenges. Blunders made at the start, even those which sound slight, could cause major problems down the road.
Bearing this in mind, we’ll take you through the process of installing floor tile in your residence or place of business. It’s not an easy task. Make sure you possess the required materials and equipment beforehand, in order to prevent rushing for them later on
Furthermore, subdue the longing to rush the task. Being scrupulous pays off when you inspect your newly-set up tiled floors.
Lay Out The Tiles And Note The Intended Design
Tile layout in advance of installation is vital for a couple of reasons. To start with, the surfaces of the pieces will vary from one another; by organizing their layout upfront, you could control how they should appear. Patterns displayed on the surfaces could be used to develop particular visual effects within the room in which the pieces will be set up.
The second reason for installing the tile ahead of time is to ascertain the placements of the specific pieces. Along with their surface areas presenting differing design patterns, a few of the pieces might be oddly-shaped
Coordinating their positions ahead of time will certainly eliminate lots of uncertainty once you start setting up the pieces.
Remove All Dust And Debris From The Flooring Surface
Before you begin tiling the space, closely examine every bit for small dust. While the supplier will go to great lengths to keep the flooring free of dirt, it is nearly impossible to do so completely
Left over debris can easily find its way onto the tiles’ surfaces. The problem is, this kind of debris will be caught between the surface areas and the adhesive mortar (thinset) when you lay the sections. This could cause the glue to bubble.
Once more, examine the pieces. Scrape off dirt and every other substance you see (it is important to have a scraper readily available).
Set Up And Spread Out The Thinset Adhesive
After eliminating dust from the tiles, prepare the thinset. It’s available in powder form, and needs to be combined with water (or an adhesive material). Utilize a paddle mixer to stir the thinset right up until it has a consistency much like mayonnaise. Then, allow it to stay for several minutes before you apply it.
It is advisable to employ the material in small amounts. Utilizing a trowel, scoop up an amount adequate for covering a spot a couple of feet wide with a thin coat. Apply it with the straight side of the trowel; then, scoop up a bigger amount to apply a fuller coat with the ridged end.
Place The Tiling (Look At Notes)
Put the very first tile onto the thinset. Apply pressure to its surface with your fingertips, making sure the tile is situated straight (or consistent with the intended design). Once you’re certain the tile is placed the right way, and firmly held by the thinset, lay the very next piece. Put a spacer between your two floor tiles to keep them split up.
While you lay following tiles, be sure to apply the same measure of thinset. Otherwise, some tiles will wind up higher than others.
Shaping The Perimeter Tiling
The tiles near the fringe of the installation area will have to be cut in order to fit in the available space. This can be done with a snap tile cutter. You can even use a wet tile saw, but doing so demands more effort – and expense, since it is a bigger piece of equipment – than is generally justified.
Remember that cutting floor tile is unlike cutting many other materials. Breakage is normal, and a blunder will basically ruin the tile. Thus, it’s a very good idea to train on a few floor tiles to get accustomed to utilizing the cutter.
Tile set up is a time-intensive job that demands focus; the process described above is shortened and doesn’t tackle grout application, an important step. If you’re uncertain with regards to whether you should move forward with such a task, you might be well-served by hiring a specialized floor tile contractor.