With regards to installing an in-ground post mounted letter box there is more to it than digging a big hole and dropping in the post. You will also need to make a couple of telephone calls before you start to dig and whenever done properly, the in ground mail box post will stay in place for decades to come.
You’ll notice different styles of post mounted letterboxes. Everything from a normal post to the variations that have a horizontal mount on what the letterbox is secured and installation will essentially be the same, given that the trickiest part will be setting up the post.
Before you decide to dig any holes for the post, it is best to contact the power companies to make sure you don’t dig into any kind of power, water or other utility lines that may be below ground. You will also want to call a nearby post office to obtain specialized details about the height of the letterbox and the space from the edge of the road. If your residential letterbox is not mounted as outlined by their criteria, the mail carrier won’t deliver your mail.
Usually, the top post, or bottom level of the roadside mail box needs to be about 33-inches from the level of the road. The front of the post ought to be about 12-inches from the edge of the road. These dimensions are a standard and may differ in your area and will rely on whether there’s a curb on the road or the road is the identical level as the front of your lot.
You might need a post hole digger, a level, at least 24-inches long and some ready-mix concrete. Be sure to get the type that you pour into the hole and add water since it is much easier. The hole must be at a minimum 24-inches deep and no greater than 8- inches across. The hole may be deeper with regards to the length of the hole you are utilizing.
When the hole is deep enough, set the pole in the hole and pour in the dry cement mix until it fills up about a fourth of the ditch. Making use of the level, check it on all sides to verify it is straight. Then add more dry concrete to around half the depth. Just as before check with your level. Tap the dry cement to pack it down and use a garden hose to extremely slowly add water until finally it rises to about one inch higher than the dry concrete.
Right after it’s soaked into the concrete floor, check with your level just as before and then add more dry concrete to within just one inch of the top of the hole. Add more water and then vanish and let it set for at the very least 24 hours before hanging the letter box to the very top of the pole.